Pipeline & Piling Services Company Limited
PAPS - PIPELINE & PILING SPECIALISTS
OUR COMPANIES
CHANGE LANGUAGE
Switch to English
Switch to Thai
           
 
 
  i) Onshore   ii) Subsea Pipelines   iii) Jacket & Platforms   iv) Seabed Stabilization   v) FPSO
   



Quick Links :
Enerpac
Cape Holland
Helicoid
KaMOS
Morgrip
NDT Services
Seabed Systems
Sensorlink - NEW !
STATS Group
Subsea Innovation
PAPS ISO9001 Certification
IMCA, the International Marine Contractors Association


PAPS NEWS
STATS GROUP - PTTEP (GasBag 18")



In order to mitigate the risk of the ignition (flash off) of flammable vapours or gasses, a vapour barrier is a recommend best practice during hot work operations particularly those that are carried out on existing hydrocarbon service pipe work systems.

The flow of hydrocarbon medium under pressure through a pipe work or pipeline system will, over time, impregnate the scale and the superficial inner surface of the pipe and also the fabric of any hardware and fittings pertaining to the system. During maintenance periods, when the system has been depressurized cleaned and purged, the ambient pressure within the pipe work allows flammable gases and vapours to be released from any residual hydrocarbon debris, and these vapours may build up to a level of concentration that will be, potentially explosive.

Figure 1 – Gas Bag arranged as a dual vapour barrier to allow hot work
Figure 1 – Gas Bag arranged as a dual vapour barrier to allow hot work

The installations of a verified vapour barrier mitigate the risk of this explosive mixture migrating to the hot work area and encountering the source of ignition that will cause explosion (flash-off).

The dual gas bag assembly provides a verified vapour migration barrier to significantly reduce the risk of ignition (flash off) of flammable vapours or gasses during hot work operations. The barrier is created by inflating the front and rear bags and introducing an inert gas such as nitrogen or argon at a positive pressure between the bags.
Dual gas bag assemblies are an ideal solution to the requirement for a vapour barrier in situations where the access to the pipe work is restricted or the location of the vapour barrier is required through a branch or beyond an elbow. The Gas

Bag vapour migration barrier is created by deploying the dual bag assembly into the existing pipe work, inflating the front and rear bags and introducing a positive pressure inert gas into the void between the front and rear bags.

For Hot Work
the rear gas bag must be located beyond the reach of the thermal conduction from the heat source along the pipe work. (The rear bag must be a minimum of 1500mm from the heat source).

The Gas Bag vapour barrier must not be installed in a pipe or system where there is the potential for pressurisation of the atmosphere contained by the barrier. The containment atmosphere must be maintained at ambient pressure.isolate and install a suitable bypass line.

Figure 2 – During FAT at PTTEP workshop Songkhla
Figure 2 – During FAT at PTTEP workshop Songkhla

With the animation can be found at www.paps-thailand.com/statsgroup.htm

Figure 3 – Deployed Dual Gas Bag into pipe spool
Figure 4 – Pressurise Dual Gas Bag during FAT

Figure 3 – Deployed Dual Gas Bag into pipe spool

Figure 4 – Pressurise Dual Gas Bag during FAT


Download as a PDF file

(back to main NEWS page)

Paps Thailand
Paps Thailand
Paps Thailand
Paps Thailand
Paps Thailand
Paps Thailand
Paps Thailand
Paps Thailand
Copyright © 2017 : PAPS-THAILAND.COM : All Rights Reserved
Web Design, Web Hosting, Web Marketing - ThaiWebpro.com
Site developed by : www.thaiwebpro.com